OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3023

Control Module Input Power Circuit A - Ignition Input On/Start Circuit Correlation

U3023 means a module sees clearly different voltages on its permanent battery feed A and its switched run/crank input while both should be live. GM's 2025 engine and transmission control modules (25OBDG04B, 25OBDG03B and others) run this check once a battery is detected, run/crank is active and the starter is not engaged: a difference above 3 V in 40 of 50 samples fails it, in some ECM variants 50 of 63. The TCM entries are Type A and most ECM entries Type B, both with MIL; one 2025 ECM list (25OBDG04A) keeps it as Type C without MIL. GM bulletin 24-NA-124 shows a typical cause on 2020–2025 Silverado and Sierra 2500/3500: the ECM harness rubs through at the driver-side upper control arm bracket, giving U3023 with P2534, P0700 and others, a lit MIL, a stall or a no-start; the harness is repaired and tied away from the bracket.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 23

Possible causes

  • Module harness chafed against a bracket, interrupting feed or ignition wire high
  • Faulty run/crank relay or fuse feeding the ignition input medium
  • Voltage drop on the battery feed from a loose terminal or corroded fuse medium
  • Faulty voltage sensing inside the module low

Symptoms

  • MIL on, often with several other codes from the same module
  • Engine stalls or does not start
  • Transmission faults when the TCM stores it

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U3023

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication