U3020
Control Module Wake-up Circuit B High
U3020 sets when wake-up line B stays above its valid level, typically through contact with a battery or ignition feed, or because its source holds it on. The practical effect differs from U301F: a permanently active B line keeps asking the module to stay awake even when line A and the bus have gone quiet, so the module cannot enter sleep and the 12 V battery runs down while parked. Ford's 2019 hybrid OBD summary shows how much a high wake level can trigger, since its battery module starts contactor checks whenever the charge wake-up is high. At the same time a transceiver such as NXP's TJA1043 only wakes on a level change, so the fixed high line cannot pass on a real request from source B. No manufacturer documents U3020 publicly. A parasitic draw test with the line unplugged confirms the cause.
Possible causes
- Wake-up wire B shorted to a battery or ignition feed high
- Source on line B holding its output on medium
- Moisture bridging line B to a supply pin low
Symptoms
- 12 V battery flat after parking
- Module stays awake with the vehicle locked
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U3020
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.