OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U301D

Control Module Wake-up Circuit A Performance

U301D says wake-up line A is electrically intact but its level does not fit what the module expects at that moment. Ford uses it in the battery energy control module of the 2019 Fusion Energi plug-in hybrid. Its OBD summary files the code under the charging performance checks: while the charger is precharging and its output voltage is already within the window for closing the charge contactors, the BECM still sees the charge wake-up line low before it has asked for the contactors to close. Ford's TSB 18-2386 and SSM 47630 report U301D with a lit MIL after charging on cars built up to 2 Oct 2018; if it is the only BECM code, the PCM and BECM are reprogrammed together (0.5 h) under the emissions warranty. Charging is normally unaffected, but the MIL stays on until cleared.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 1D

Possible causes

  • BECM and PCM software judging the wake-up timing too strictly high
  • On-board charger raising its wake-up signal late or unsteadily medium
  • High resistance in the charge wake-up wire or connector low

Symptoms

  • MIL on after a charging session
  • Code is the only entry in the battery control module

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U301D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication