OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U301C

Control Module Wake-up Circuit A High

U301C is the opposite of U301B: wake-up line A is stuck high, usually shorted to a battery-fed wire or held up by a sender that never releases it. The receiving module then gets a permanent wake request. In Ford's 2019 hybrid OBD summary, a high charge wake-up signal is one of the conditions under which the battery energy control module runs its charge contactor and pack contactor checks, so a line stuck high makes the module behave as if charging were requested. The likely result is a module that never falls asleep and a 12 V battery that is flat after a few days of parking. A transceiver like NXP's TJA1043 also needs a change of level to register a wake, so a permanently high line cannot deliver a fresh wake event either. No manufacturer documents U301C publicly.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 1C

Possible causes

  • Wake-up wire shorted to a battery or ignition feed high
  • Sending module or charger holding the wake output on medium
  • Moisture bridging the wake pin to a neighbouring supply pin low

Symptoms

  • 12 V battery drained after the vehicle has been parked
  • Module or fan audible or active with the vehicle switched off

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U301C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication