OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U301A

Control Module Wake-up Circuit A/Open

A wake-up circuit is a separate wire that rouses a sleeping module without bus traffic, for example when a charge cable is plugged in or another controller needs it. U301A reports that line A has lost continuity, so no valid signal reaches the input. Ford's 2019 hybrid OBD summary shows such a line in use: the battery energy control module relies on a hardwired charge wake-up signal before it runs its charging and contactor checks. No manufacturer documents U301A publicly. GM's PIT6198 for 2019–2022 Silverado and Sierra shows the consequence of a lost wake input at the ECM (circuit 5985, about 12 V with the BCM awake): other modules report U0100 and the service engine lamp comes on, with possible shift complaints. An open wake line usually means the module stays asleep or joins late.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 1A

Possible causes

  • Broken wake-up wire or pushed-out connector pin high
  • Corroded or loose contact at the sending or receiving module medium
  • Sending module or charger not driving the wake-up output medium
  • Blown fuse in a supply-fed wake circuit low

Symptoms

  • Module does not respond, other modules report lost communication
  • Charging or a function that needs the wake-up does not start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U301A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication