U3019
Control Module Input Power Circuit B/C Correlation
U3019 pairs the second and third supply of a module and reports that they drift apart. The one published use comes from GM's electric brake booster module in the 2016 and 2018 hybrid tables (16OBDG02, 18OBDG01). There, one voltage sensor watches the booster circuit supply and a second one the supply of the motor driver; the module divides the two readings and sets U3019 when the ratio rises above 1.321 or falls below 0.766 for 2 s while running or shutting down. GM describes this as a check for drift of the voltage divider, so besides a weak feed a measuring fault inside the module is a real candidate. The code is Type A, meaning MIL on the first trip, and it passes after about 5 s with ignition on. Because the booster supports braking, expect a brake warning and possibly reduced assist.
Possible causes
- Voltage loss on one feed from a corroded fuse, terminal or splice medium
- Drift of the voltage divider or sensor inside the module medium
- Motor driver supply sagging under load from a faulty booster motor stage low
Symptoms
- MIL and brake system warning on the first trip
- Reduced or harder brake pedal assist
- Often stored with input power low or high codes of the same module
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3019
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.