U3015
Control Module Ground C
U3015 reports that the third ground path of a module, labelled C, is missing or no longer plausible. Three or four separate grounds are found mainly on units that drive heavy loads, such as brake, steering or power distribution modules, where control electronics and power stages return current through their own wires. No manufacturer documents U3015 publicly. The published logic for grounds A and B gives the pattern: GM's 19OBDG03B brake module compares the voltages on two grounds and flags one as lost once the ratio leaves ±0.9, and Ford's 26-2150 ties each ground letter to a specific body point. Which pin is C is defined only by that module's wiring diagram. A failing ground C can bring warning lamps, a disabled function or erratic readings from the same module.
Possible causes
- Corroded or loose ground eyelet at the body or frame point high
- Chafed or broken ground wire between module and ground point medium
- Spread or corroded ground pin in the module connector medium
- Internal fault in the module's ground measurement low
Symptoms
- Warning lamp or message for the system run by the affected module
- Function cut back or switched off, often depending on load or moisture
- Stored together with other supply or ground codes of the same module
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U3015
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 1 warning for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.