OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3010

Ignition Input Start

U3010 concerns the start or crank request input, which should be active only while the key or button is held in Start. A module sets it when it sees a start signal outside a valid crank event, or misses one although the network reports crank. In GM's 2012 truck wiring manual the start position is the only one in which the run/crank line is active while the accessory line is off, so the start state is recognised from a combination of lines that must change together. No manufacturer documents U3010 publicly. The moment of transition is delicate: Ram found that the 2025 heavy-duty LED headlamp modules flag the run-to-start change as invalid (U300A-29) and treat it as harmless if stored only, which shows that a code logged exactly at cranking can be a software artefact rather than a wiring fault.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 10

Possible causes

  • Worn start contact or push-button in the ignition switch medium
  • Start request wire open or shorted to voltage medium
  • Module software misreading the run-to-start transition medium
  • Supply dip during cranking upsetting the input reading low

Symptoms

  • Engine does not crank or cranks with a delay
  • Code stored at each start with no further complaint

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U3010

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication