OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U300E

Ignition Input On

U300E deals with an ignition input that should be live only in On, without Start. Such run-only feeds exist because many loads are shed while the starter turns; GM's 2012 truck wiring manual, for instance, keeps its retained accessory power relay energized in all modes but two, crank and off-awake. If a module sees this run-only line high in Off or Accessory, or low while the network reports run, it stores U300E. A brief drop during cranking is intended and must not be judged as a fault, so a module that flags the code right after every start points more to a timing or software issue than to wiring. No manufacturer documents U300E publicly. A real wiring fault usually leaves functions on that feed dead with the engine running, which helps to separate the two cases.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 0E

Possible causes

  • Blown fuse or faulty run relay on the run-only feed medium
  • Input wire open, shorted or backfed medium
  • Module software misjudging the intended drop during cranking medium
  • Worn run contact in the ignition switch low

Symptoms

  • Functions on the run-only feed dead with the engine running
  • Code logged right after each start with no other complaint

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U300E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication