OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U300C

Ignition Input Off/On/Start

U300C covers an ignition input that, going by the title, is meant to distinguish Off, On and Start rather than simply switching between live and dead. GM's 2012 light-duty truck wiring manual has exactly such a circuit, labelled Off/Run/Crank: unlike the plain accessory and run/crank feeds it takes separate states for key out or accessory, key in and off, run, and crank. A module reading a coded line of this kind sets U300C when the state it decodes is invalid or disagrees with the power mode on the network. No manufacturer documents U300C publicly. Because one wire carries several states, a slight resistance in the switch or a poor connector can shift the level into the wrong state without breaking the circuit, so measuring the line in every key position beats a simple continuity test.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 0C

Possible causes

  • Contact resistance in the ignition switch shifting the coded level high
  • Corroded or loose pin at the switch or module connector medium
  • Input wire open or shorted to ground or voltage medium
  • Faulty input stage in the reading module low

Symptoms

  • Vehicle does not switch power modes as expected, e.g. no start or no shutdown
  • Intermittent warnings that depend on key position or switch movement

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U300C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication