U3007
Control Module Input Power B Circuit/Open
U3007 is the partner code for the second battery feed, B. In GM's 25OBDG04B brake module B is KL30_2, the supply for the valve coils: the module compares it with KL30_1 and sets U3007 when it stays below 53.85 % of that value for 75 ms, and also when the switch for valve power reports less than half the supply voltage for 50 ms; Type B with MIL. The other GM brake supplier (25OBDG03B) uses U3007 differently, for charge-pump tests that could not run three times because both internal supply paths were in undervoltage. So B is a separate fused feed, not a backup of A, and a fault on B alone points to its own fuse or pin. Jeep's 08-106-21 for the 2021 Wrangler 4xe lists U3007-00 first among codes cured by charging or replacing the 12 V battery.
Possible causes
- Blown or poorly seated fuse feeding input B high
- Low battery voltage making feed B fail the comparison medium
- Damaged wire or spread terminal on supply B medium
- Valve power switch or internal supply path in the module faulty low
Symptoms
- ABS and stability control warnings, functions shut off
- Check engine light on in some vehicles
- Often stored together with U3006 when the battery is weak
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U3007
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.