OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic or reserved

U3006

Control Module Input Power A Circuit/Open

Modules with heavy loads often take more than one battery feed, and U3006 says feed A is missing or open. Which pin is A depends on the maker. In one GM brake module (25OBDG04B) feed A means KL30_1, which supplies the pump motor: if it falls below 53.85 % of the second feed KL30_2 for 75 ms, a blown fuse or short to ground is assumed, Type B with MIL. A second GM brake supplier (25OBDG03B) sets U3006 when the motor supply is under 5 V before the start-up motor test, also Type B. Both feeds there are permanent battery positive, not an ignition line. Jeep's 08-106-21 lists U3006-00 next to U3007-00 on 2021 Wrangler 4xe with a weak 12 V battery and MIL, and Mazda's SA-023-23 shows U3006:01 in the CX-5 parking brake module after battery drain.

SystemNetwork
Typegeneric or reserved
GroupU3
Range / number– / 06

Possible causes

  • Blown or loose fuse in the feed A path high
  • Discharged 12 V battery pulling the feed below the check limit medium
  • Corroded terminal, loose pin or chafed wire on supply A medium
  • Internal power switch or board fault in the module low

Symptoms

  • ABS, stability or parking brake warning lamps on
  • Function of the module limited or switched off
  • Check engine light on in some vehicles

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U3006

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication