U3000
Control Module
U3000 is the catch-all for a fault inside the module that stores it; the attached failure-type byte says what kind. GM's front camera module uses :41 checksum, :42/:44 memory, :49 internal electronics and :51 not programmed, all without MIL, and then drops adaptive cruise. In a GM brake module the same code covers hardware self-tests and is Type A, while Ford's 2014 Boss 302S list marks U3000 in the PCM as MIL-relevant. Ford SSM 47982 notes that the cruise module of 2017–2019 Super Duty trucks can log U3000:49 after a weak battery: if it stays away after clearing, the module is kept. Mazda (15-002/19) replaced forward cameras that stored a permanent U3000:04. The module named in the scan matters more than the code.
Possible causes
- Weak or discharged battery leaving a stored internal-fault entry high
- Module software or calibration that needs an update or reprogramming medium
- Real internal defect such as memory or processor failure in the module medium
- Module running too hot, e.g. a windshield camera in strong sun low
Symptoms
- Warning or service message for the system run by the affected module
- Assistance or comfort function switched off, e.g. adaptive cruise or lane keeping
- Often no noticeable fault if the entry came from a one-off voltage dip
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U3000
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 1 affected component(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.