U069A
Lost Communication With Exhaust Gas Temperature Sensor Bank 1 Sensor 3
The third exhaust temperature sensor on bank 1 usually sits in the aftertreatment, ahead of the filter or SCR stage. GM covers U069A in both 2025 diesel tables, 25OBDG04A and 25OBDG04B: a SENT sensor whose output was switched off by an internal fault, or that sends faulty or outdated messages, fails the check once 19 readings out of 25, taken every 100 ms, are bad. The test waits for the sensor start-up delay and skips cranking; Type A, so the lamp lights in the first faulty trip. GM's regeneration control reads EGT 3 as the temperature ahead of the particulate filter, and the circuit-low test P242C treats a digital reading under -72.8 °C as faulty. Ford's 2023 diesels have sensor 3 as an analog probe (P242C/P242D, below 0.10 V or above 2.66 V). Sensor 4 is U069B.
Possible causes
- Sensor harness along the aftertreatment burnt or chafed high
- Electronics module of the thermocouple sensor failed medium
- Connector corroded medium
- Controller input fault low
Symptoms
- Check engine light, on GM diesels in the first trip
- Particulate filter regeneration blocked or postponed
- Further code for the controller input
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U069A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.