U0693
Lost Communication With Humidity Sensor
Intake air humidity influences combustion temperature and NOx, so some engines measure it, usually with a capacitive element built into the air-mass meter; Bosch offers such meters with optional humidity sensing over SENT, FAS or LIN. GM's dual-throttle tables 23OBDG07/24OBDG07 use U0693 for a SENT humidity sensor on bank 1, stored when the sensor itself reports a maximum or minimum error for 1 s, MIL after two trips; the same program has P00F4 to P00F6 for the reading and GM codes for invalid data. Other layouts avoid U0693: GM's 25OBDG04A treats a silent LIN air-mass meter as U060F, and Ford's 2023 diesel sets P00F2 for bad SENT humidity message timing. Fuel and EGR then run on default humidity.
Possible causes
- Humidity element in the air-mass meter contaminated or failed high
- Signal or supply wire to the sensor faulty medium
- Moisture or corrosion in the connector medium
- Engine controller software fault low
Symptoms
- Check engine light after two trips
- Usually no noticeable drivability change
- Accompanying humidity or air-mass codes possible
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for U0693
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.