U068C
Lost Communication With Turbocharger/Supercharger Inlet Pressure Sensor B
A second inlet pressure sensor makes sense where each bank breathes through its own filter and charger, or where a two-stage system needs the pressure ahead of the second compressor. U068C means the digital frames from that sensor B no longer arrive in usable form. No manufacturer documents U068C publicly; Ford's 2023 diesel summary, the only examined table with an inlet pressure U code, runs just sensor A over SENT (U068B), and no GM table lists either code. Faults of an analog sensor B are P2374 to P2378. CARB lists compressor inlet pressure among the required diesel data. The controller then models the pressure on that side, so filter restriction there goes unseen and boost targets get more cautious.
Possible causes
- Signal, supply or ground wire to inlet sensor B damaged high
- Connector loose or contaminated with oil medium
- Sensor B electronics failed medium
Symptoms
- Check engine light
- Filter restriction on that side no longer detected
- Slightly lower boost possible
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for U068C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.