OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U068A

Lost Communication With Barometric Pressure Sensor C

Barometric sensor C appears in two very different layouts. In GM's dual-throttle tables 23OBDG07/24OBDG07 it measures the air ahead of the bank 1 throttle; P227C and P227D judge its raw value (under 50 or over 115 kPa, 2 s), and U068A is set once the bank 1 SENT frames carry an incorrect length for 1.5 s, two trips to MIL. Oddly, GM's description calls the part pressure sensor 2 although the frames are labelled bank 1. GM's diesel tables 25OBDG04A/04B place sensor C inside a LIN air-mass meter instead: a low reading there sets P227C (Type B), but a missing reply is logged as U060F for the meter, not as U068A. U0680 is the bank 2 partner. The controller falls back on modelled pressure.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 8A

Possible causes

  • Signal, supply or ground wire to sensor C damaged high
  • Connector at the intake pressure sensor loose or corroded medium
  • Sensor C electronics failed medium
  • Engine controller software fault low

Symptoms

  • Check engine light after two trips
  • Bank 1 fueling less precise
  • Accompanying pressure codes P227B to P227D possible

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U068A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication