OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0688

Lost Communication With Throttle Position Sensor/Switch G

Throttle sensor G is the second track of a second throttle body. GM's 23OBDG07 and 24OBDG07 tables, for a program with one throttle per bank, use it for throttle position sensor 2 on bank 2. Both tracks of that throttle travel in one SENT stream, so GM sets U0688 together with U0608 (sensor 1, bank 2) when the line carries no signal, pulse widths fall outside their window or the calibration pulse is off, within 0.13 s and MIL in one trip. NXP's KMA215 shows why: its dual throttle format packs the angle and its inverted copy into a single frame. Raw value checks of track G are P212C under 0.195 V and P212D over 4.805 V, P212B checks synchronisation. Bank 2's throttle can then no longer be positioned reliably, so power is reduced.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 88

Possible causes

  • SENT, supply or ground wire to the bank 2 throttle body faulty high
  • Throttle body connector loose, wet or corroded medium
  • Sensor electronics in the throttle body failed (replaced as a unit) medium
  • Engine controller SENT input fault low

Symptoms

  • Check engine light on the first trip
  • Reduced power, uneven running between banks
  • U0608 stored at the same time

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0688

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication