OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0687

Lost Communication With Catalyst Temperature Bank 2 Sensor 2

U0687 refers to the rear catalyst temperature probe of bank 2, the one behind the converter brick on the second cylinder row. Once its digital messages stop, the controller can no longer compare bank 2 inlet and outlet temperatures (P046B) and loses an over-temperature guard: such probes have long been used to warn when a converter runs hotter than it can tolerate, which on older two-way designs was around 750 °C. No manufacturer documents this code publicly, so MIL timing and debounce are not known; CARB only requires that silence of a digital input sets its own code. Analog faults at this point are P043A to P043D, and sensor 1 of the same bank is U0686. The car usually drives normally, but the fault should not be left, since misfires could go on overheating the converter.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 87

Possible causes

  • Lead of the rear bank 2 probe damaged high
  • Sensor electronics failed after overheating medium
  • Connector corroded low

Symptoms

  • Check engine light
  • Bank 2 temperature comparison not possible
  • No noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0687

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication