U0684
Lost Communication With Catalyst Temperature Bank 1 Sensor 1
A catalyst temperature sensor tells the controller when the converter is hot enough to work and to be tested. Sensor 1 on bank 1 is the first such probe on the bank that holds cylinder 1. U0684 applies when the probe sends its reading as a digital message and that message has stopped. No manufacturer documents this code publicly, and many makers fit no sensor here: Ford's 2024 gasoline summary works with an inferred mid-bed temperature and only runs its catalyst test between 510 and 815 °C of that model value. CARB accordingly lets the catalyst temperature in the data stream be measured or estimated, but wants a separate code for every silent digital input. Analog circuit faults at this point are P0425 to P0428; U0685 covers sensor 2.
Possible causes
- Sensor lead near the converter burnt or chafed high
- Evaluation electronics of the temperature sensor failed medium
- Corroded connector under the vehicle medium
- Engine controller input or software fault low
Symptoms
- Check engine light
- Catalyst readiness monitor does not complete
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0684
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.