OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0681

Lost Communication With Throttle/Pedal Position Sensor/Switch D

In the generic code scheme the letters D, E and F normally mark the accelerator pedal tracks, while A to C and G belong to throttle bodies. U0681 is meant for a pedal module whose first track D reports digitally, for example over SENT or SPC as offered by Melexis' MLX90377 position IC, which lists pedal sensors as an application and comes as a fully redundant dual die. No manufacturer documents U0681 publicly. Ford (2024 gasoline) and GM read pedal D analog: Ford sets P2122/P2123 below 0.25 or above 4.75 V within a second, with wrench lamp and MIL. Ford also explains the fallback when one pedal input is lost: driver demand follows the remaining track at a limited rate. CARB requires pedal and redundant pedal position in the diesel data stream.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 81

Possible causes

  • Wiring to the pedal module chafed in the footwell or at the bulkhead high
  • Pedal module connector loose or corroded medium
  • Sensor electronics in the pedal module failed (replaced as a unit) medium
  • Engine controller input or software fault low

Symptoms

  • Check engine light and possibly a powertrain warning
  • Sluggish, rate-limited throttle response
  • Reduced power

Inspection / repair

  • Difficulty: easy
  • DIY: possible

What Pro shows you for U0681

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication