OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0680

Lost Communication With Barometric Pressure Sensor B

The letter B need not mean a second ambient sensor; it can be any further pressure input that sees near-atmospheric air. GM's 23OBDG07 and 24OBDG07 tables, written for a program with two throttle bodies, use barometric sensor B for the pressure ahead of the bank 2 throttle and send it over SENT. U0680 is stored when the frames carrying the high and low line pressure of bank 2 come in with a wrong data length code for 1.5 s; the MIL follows after two trips. The checks of the value itself are P222C and P222D (raw reading under 50 or over 115 kPa) and P222B (plausibility against ambient pressure). U068A covers the bank 1 counterpart. Air mass on bank 2 then has to be estimated without its reference.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 80

Possible causes

  • SENT signal, supply or ground wire to the bank 2 pressure sensor faulty high
  • Connector at the sensor ahead of the throttle loose or wet medium
  • Pressure sensor sends malformed frames medium
  • Engine controller software or SENT input fault low

Symptoms

  • Check engine light after two trips
  • Uneven running between banks possible
  • Additional pressure plausibility codes

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0680

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication