U067E
Lost Communication With Exhaust Pressure Control Valve B Sensor/Switch
An exhaust pressure control valve is a flap in the exhaust that diesels close partly to raise back pressure, which speeds warm-up and helps reach filter regeneration temperatures. Valve B is a second flap of this kind, and U067E concerns its position sensor or switch when that reports digitally: the controller has lost its messages. Public manufacturer documentation for U067E is lacking. GM's 2025 diesel table 25OBDG04B shows the pattern for valve A, a SENT position sensor whose silence gives U0650 after 480 failed checks out of 600 at 6.25 ms, Type A. For valve B, drive faults run from P049F to P04A5 and analog position faults from P04A6 to P04AA. CARB wants a separate code for a mute digital input. Warm-up and regeneration may be impaired.
Possible causes
- Sensor wiring at valve B damaged by exhaust heat high
- Connector at valve B corroded or loose medium
- Position sensor in the valve B unit failed medium
- Engine controller input or software fault low
Symptoms
- Check engine light
- Particulate filter regeneration delayed or not started
- Longer warm-up in cold weather
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U067E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.