U067B
Lost Communication With Engine Disconnect Clutch Pressure Sensor
Parallel hybrids put a clutch between engine and electric motor so the car can drive electrically with the engine stopped. Many close it hydraulically, and a pressure sensor confirms the clamping: in Ford's 10R80 MHT hybrid transmission, as Gears Magazine explains, the auxiliary pump closes the clutch and a pressure sensor watches that supply. Schaeffler's application WO2018233759A1 places a pressure sensor in the clutch actuator's master cylinder next to a travel sensor. If such a sensor reports digitally and its messages stop, U067B is stored. No manufacturer documents this code publicly. Analog faults of the same sensor are P28F1 to P28F5; U02AA concerns the clutch actuator. Engine starts and electric driving may then be restricted.
Possible causes
- Wiring or connector of the clutch pressure sensor damaged high
- Pressure sensor electronics failed medium
- Transmission or hybrid controller input or software fault low
Symptoms
- Hybrid system warning, electric driving unavailable
- Engine runs continuously or starts roughly
- Check engine light
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U067B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.