OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0679

Lost Communication With Transmission Fluid Pressure Sensor/Switch A

Automatic transmissions measure hydraulic pressure to confirm that a clutch or pulley really received the pressure the controller asked for. Which sensor is A varies: Ford's 2024 summary calls the sensors of its 10R60/10R80 and 8F units TFP A and B, analog with 0.5 to 4.5 V for 0 to 2,500 kPa, and sets P0841 when the reading sticks although the clutch still applies and releases. GM's 24OBDG07 assigns A to clutch 1 (P0842 below 220 mV, P0843 above 4,530 mV after 150 ms), while its CVT table 25OBDG03A uses A for the primary pulley. U0679 covers a digital sensor A that has gone silent. No manufacturer documents this code publicly. The transmission controller then loses its pressure feedback and may hold a gear or shift harshly.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 79

Possible causes

  • Transmission internal harness or lead frame to sensor A damaged high
  • Transmission case connector leaking oil or corroded medium
  • Pressure sensor A electronics failed medium
  • Transmission control module input or software fault low

Symptoms

  • Harsh or delayed shifts
  • Transmission stays in a fixed gear
  • Check engine or transmission warning light

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0679

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication