OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0676

Lost Communication With Fuel Level Sensor A

Fuel level sensor A is the main tank sender. Usually it is a float-driven resistor read as a voltage, and U0676 only applies where the sender itself reports digitally and its messages stop. Public documentation of this code from any manufacturer is lacking. In its 2024 summary Ford treats sender A as a resistance: below 5 ohms or above 200 ohms within 30 s are circuit faults, more than 100 jumps of over 40 % are noise, and stuck checks need 100 to 120 miles. GM's 25OBDG03A lets the float feed the engine controller directly or a fuel tank zone module, which forwards the value, and pauses its range checks while a communication fault is active. CARB needs the level for EVAP testing and misfire disablement at low fuel, so the gauge may be wrong and those monitors stay incomplete.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 76

Possible causes

  • Wiring at the tank or fuel pump flange damaged or corroded high
  • Electronics of the level sender failed medium
  • Module that reads or forwards the level faulty medium
  • Connector under the vehicle not latched or water-damaged low

Symptoms

  • Fuel gauge reads empty, full or freezes
  • Range display missing or wrong
  • Check engine light, EVAP readiness not set

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0676

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication