OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0675

Lost Communication With Turbocharger/Supercharger Speed Sensor A

A speed sensor in the bearing or compressor housing lets the controller watch how fast the turbocharger rotor spins, mainly to keep it below its overspeed limit; a BorgWarner patent (US9353760B2) describes such a sensor and gives that reason, and CARB names turbocharger/turbine speed among the data diesel vehicles must output. Classic sensors send a pulse train whose faults are P2578 to P2582. U0675 applies when sensor A delivers the speed as a digital message and those messages are missing or invalid. No manufacturer documents this code publicly. Without a speed value the controller cannot tell how close the rotor is to its limit, so it will usually cap boost and engine power until the fault is gone.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 75

Possible causes

  • Sensor wiring near the turbocharger heat-damaged or broken high
  • Connector loose, oily or corroded medium
  • Speed sensor electronics failed medium
  • Engine controller input or software fault low

Symptoms

  • Check engine light
  • Boost and power limited
  • Noticeably weaker acceleration at higher loads

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0675

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication