OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0670

Lost Communication With Fuel Temperature Sensor A

GM's 2025 direct-injection engines measure fuel temperature in the high-pressure rail with digital SENT sensors, and sensor 1 is the one GM files under U0670. The test counts pulses on the signal wire: if the line sits permanently high and four or fewer pulses arrive (25OBDG03A; 40 or fewer in 25OBDG03B), a sample fails, and 400 bad samples in a window of 500, one every 6.25 ms, set the code; being Type A, it lights the MIL during the first trip. While it is active, GM holds back the range checks P0182/P0183 and the sensor comparison P111F. CARB requires a separate code when a digital input stops talking. The controller then substitutes a fuel temperature, so drivability rarely changes; the fault lies in wiring, connector or sensor.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 70

Possible causes

  • SENT signal wire to sensor A shorted or open high
  • Connector at the fuel rail loose or contaminated medium
  • Fuel temperature sensor A internally failed medium
  • SENT receiver in the engine controller faulty low

Symptoms

  • Check engine light from the first trip
  • Usually no noticeable change in driving
  • Occasionally rougher hot restarts

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0670

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication