OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U066F

Lost Communication With Low Pressure Fuel System Sensor

The low-pressure side of a direct-injection fuel system runs from the tank pump to the high-pressure pump, and a sensor there lets the controller regulate the lift pump. If that sensor transmits a digital value, for example over SENT, U066F records that its messages have stopped. None of the public manufacturer documents uses the code. GM's 2025 table 25OBDG03A reads its low-side sensor, labelled fuel pressure sensor B, as a 5 V analog input at the engine controller or the pump module and fails P018C below 4 % of reference (64 failed samples in 80, Type B). Ford's 2024 summary flags its low-pressure rail sensor below 0.049 V or above 4.88 V within 8 s. Analog faults of this sensor are P2539 to P2543. Expect a MIL and possibly hard starting or hesitation under load.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 6F

Possible causes

  • Signal, supply or ground wire to the low-pressure sensor damaged high
  • Connector at the sensor or fuel line corroded or not latched medium
  • Sensor electronics failed and no longer transmit medium
  • Receiving input or software of the engine or pump control module faulty low

Symptoms

  • Check engine light
  • Longer cranking or hard starting
  • Hesitation or power loss under heavy load

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U066F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication