OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U066C

Lost Communication With Exhaust Heat Exchanger Bypass Valve Actuator B

Exhaust heat recovery sends hot gas through a coolant heat exchanger after a cold start and later steers it past; the steering is done by bypass flaps. Actuator B is the second such flap, present only where the layout has two paths or stages. U066C is logged once that actuator, linked over a serial bus such as LIN, stops answering the controller. No maker has published a definition for this code. The nearest published check covers actuator A: GM's hybrid tables from 16OBDG02 on set U063E after 80 unanswered LIN requests at 40 ms (about 3.2 s), Type B with the MIL after two trips; no table lists a B actuator. CARB requires lost communication of digital parts to be detected separately. Hardware faults of flap B are P23A2 to P23A8. Expect slower warm-up in cold weather.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 6C

Possible causes

  • Actuator B electronics damaged by exhaust heat high
  • LIN, supply or ground wire under the vehicle damaged medium
  • Water or salt corrosion in the actuator connector medium
  • Low supply voltage during the check low

Symptoms

  • Check engine light, on some systems only after two drive cycles
  • Engine and cabin heater warm up more slowly
  • Hybrid engine runs longer to reach temperature

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U066C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication