OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U066B

Lost Communication With Turbocharger/Supercharger Bypass Valve B Position Sensor

When the throttle snaps shut, a compressor bypass valve lets boosted air recirculate to the inlet side instead of surging against the closed plate. Engines with two chargers or two compressor stages can carry a second such valve, and if its electric actuator reports the opening angle as a digital message, U066B means the engine controller no longer gets valid position frames from valve B. No manufacturer documents this code publicly. Ford's 2024 gasoline summary checks bypass valve B only for circuit faults (P00C1/P00C2 after 5 s) and lists no position feedback for it. Analog position faults on valve B would be P2C2A to P2C2C; valve A has U0657. CARB demands a separate code for lost communication of digital inputs. Boost is usually limited.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 6B

Possible causes

  • Signal, supply or ground wire to the bypass valve B actuator damaged high
  • Connector at the valve loose, corroded or heat-damaged near the turbo medium
  • Position sensor electronics in the valve actuator failed medium
  • Engine controller input or software fault low

Symptoms

  • Check engine light
  • Boost limited, reduced power
  • Compressor surge noise when lifting off the throttle

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U066B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication