OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U066A

Lost Communication With EGR Sensor E

EGR sensors A to E are open slots in the code set: each maker decides whether a slot carries a valve position, a pressure or a differential pressure in the recirculation path. U066A means the engine controller no longer gets usable digital frames from the device it calls sensor E, typically a SENT part. No manufacturer documents this code publicly. In the published tables GM gives slot A to the high-pressure valve position and C to the low-pressure one, while Ford and GM use D for a SENT EGR pressure sensor (U0669); an E appears nowhere. CARB demands its own code when a digitally coded input goes silent. Analog faults of this slot are P2385 to P2389. Most systems then cut or limit EGR, and the EGR monitor stays incomplete.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 6A

Possible causes

  • Signal, supply or ground wire to EGR sensor E damaged by heat or chafing high
  • Connector at the sensor loose, corroded or contaminated with soot medium
  • Sensor electronics no longer transmitting medium
  • Engine controller input or software fault low

Symptoms

  • Check engine light
  • EGR switched off or limited, sometimes harsher combustion noise
  • EGR readiness monitor not complete

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U066A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication