U0668
Lost Communication With Engine Oil Level Sensor Circuit
Despite the word circuit in its name, U0668 concerns the data link to the oil level sensor, not a voltage fault. Sensors in the sump measure the oil height either thermally or by ultrasound; Hella's PULS type packs an ultrasonic transducer, a temperature sensor and an ASIC into one module that sends its result to the engine controller over a single signal line, and loss of supply or ground is one listed failure cause. When that signal no longer arrives or is unreadable, a separate lost-communication code can be stored. No manufacturer documents U0668 in public. Because oil level is normally not emission-relevant, CARB's rule on separate codes for silent digital inputs hardly applies. Electrical sensor faults are P250A to P250E, low or high oil P250F and P252F. Check the dipstick until fixed.
Possible causes
- Missing supply voltage or ground at the sensor high
- Sensor electronics failed or oil inside the housing medium
- Corroded or damaged connector or harness at the oil pan medium
- Receiving control unit input faulty low
Symptoms
- Oil level warning or service message in the display
- Oil level reading unavailable
Inspection / repair
- Difficulty: easy
- DIY: possible
What Pro shows you for U0668
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.