OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0665

Lost Communication With Fuel Rail Pressure Sensor Bank 2

Engines with one fuel rail per cylinder bank may give each rail its own pressure sensor, and newer ones send the reading digitally via SENT. U0665 says the controller has lost the bank 2 sensor's data. GM's 23OBDG07 and 24OBDG07 tables pair it with GM's own code U101C: path 1 trips when the signal line stays at high level, path 2 when it stays low, each after 0.5 s and within one trip. An out-of-range raw value from the same sensor is logged separately (GM P312B), and the plausibility tests of P01BF run on top. The bank 1 sensor follows the same logic with U0625 and U101B. Analog bank 2 circuit faults are P01BE to P01C2. Without a rail pressure value the controller falls back to a substitute model; reduced power and rough running are possible.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 65

Possible causes

  • Bank 2 sensor signal wire open or shorted to ground or voltage high
  • Fuel-soaked, corroded or loose sensor connector medium
  • Rail pressure sensor electronics on bank 2 failed medium
  • Engine controller SENT input faulty low

Symptoms

  • Check engine light after one trip
  • Reduced power, hesitation or rough running
  • GM-specific code U101C stored alongside

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for U0665

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication