OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0662

Lost Communication With Right Rear Temperature Actuator B

With four rear temperature actuators, A and B on each side, plus front units, a climate system may run many look-alike motors on LIN, where one master serves up to 15 slaves. Identical parts must be told apart, either by part variant or by position detection along a daisy chain, as the LIN article explains. That makes right rear actuator B prone to a specific trap: a new or swapped unit that was never assigned its address answers on the wrong identifier, and the master logs U0662 although the part works. No maker documents this code publicly. A genuine loss only affects the fine mixing on the right rear side; actuator A keeps basic control there. Chips such as NXP's MM908E626 show the usual three-wire hookup of supply, ground and LIN.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 62

Possible causes

  • Replacement or swapped actuator B without the correct LIN address medium
  • Actuator B electronics failed medium
  • Open supply, ground or LIN pin at actuator B low

Symptoms

  • Right rear temperature imprecise or slow to settle
  • Code appears right after an actuator was replaced

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for U0662

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication