U0657
Lost Communication With Turbocharger/Supercharger Bypass Valve A Position Sensor
The bypass valve meant here sits on the intake side: on turbocharged petrol engines it lets compressed air recirculate when the throttle shuts, and on supercharged engines it routes air around the blower at light load. When the valve is electrically driven and reports its position digitally, U0657 marks that the position data from valve A has stopped arriving. No manufacturer publishes a description of U0657, so the exact valve and its protocol come from the vehicle's own service information. Analog circuit faults of the same sensor are P2BBB to P2BBD and an adaptation problem is P2BBE; valve B has U066B. Without position feedback the controller cannot tell whether surplus air is being released, so it may restrict boost to protect the compressor.
Possible causes
- Wiring to the bypass valve open, shorted or chafed high
- Loose or corroded valve connector medium
- Position sensor in the valve failed medium
- Engine controller input fault low
Symptoms
- MIL on
- Less boost or hesitant throttle response
- Unusual whoosh or flutter when lifting off
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0657
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.