U0656
Lost Communication With Turbocharger/Supercharger Boost Control A Position Sensor
On a variable geometry turbocharger the boost control position sensor reports where the guide vanes stand, and the controller needs that feedback to regulate boost and to check, as CARB 1968.2 (f)(7.2.3) asks, that the vanes reach their target in time. GM's 2025 diesel table 25OBDG04B reads this VGT position by SENT and sets U0656 when 480 of 600 checks, run every 6.25 ms, find the protocol stuck low or high with stale data, a message error, or counters that no longer update; it is Type A with the MIL in the first trip. Low raw signal level on the same sensor is a different code there, P2564. Analog circuit faults are P2562 to P2566, charger B uses U02B0. The vanes usually go to a safe position and power drops.
Possible causes
- SENT, supply or ground line to the VGT actuator damaged high
- Connector at the actuator exposed to heat, oil or water medium
- Position sensor or electronics in the VGT actuator failed medium
- Engine controller input or software fault low
Symptoms
- MIL on
- Limp mode with clearly reduced power
- Boost control codes stored at the same time
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0656
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.