U0651
Lost Communication With EGR Sensor A
EGR sensors A to D are generic slots: a maker may assign them to valve position, pressure or another EGR measurement. In GM's 2025 diesel table 25OBDG04B, which has both a high-pressure and a low-pressure EGR loop, sensor A is the SENT position sensor of the high-pressure valve. U0651 is set there if at least 480 out of 600 tests, one every 6.25 ms, find stale data with the line stuck low or high, a message error, or counters that stop, provided the relay supplies more than 11 V and no start is in progress; Type A, MIL in the first trip. A raw signal below 1 % of 5 V on the same sensor is P0405 instead. Other analog faults run through P0405 to P0409 and P046C. EGR flow monitoring stops while the position is missing.
Possible causes
- SENT line to the EGR valve damaged by heat or chafing high
- EGR valve connector corroded or loose medium
- Position sensor in the EGR valve failed medium
- Engine controller input fault low
Symptoms
- MIL on from the first trip
- EGR switched off, possibly louder combustion
- EGR monitor not ready
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0651
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.