OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U064F

Lost Communication With Intake Manifold Runner Position Sensor Bank 1

Diesel swirl flaps partly close one intake port per cylinder at low load so the charge spins and mixes better; a motor moves them and a sensor reports the angle. In GM's 2025 diesel table 25OBDG04B that sensor transmits by SENT, and U064F covers a missing or corrupt stream: an internal fault flag or message error, or position data not refreshed for over 6.25 ms with the line held steadily high or low. It must show in 480 of 600 checks taken every 6.25 ms, after cranking and with more than 11 V at the relay. As Type B it turns on the MIL only after a second failed trip. While U064F is active, GM does not judge the raw value (P2016 below 1 %, P2017 above 99 %); motor circuit faults are P2008 to P2010, failed end-stop learning P200A.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 4F

Possible causes

  • Position sensor in the swirl flap actuator failed medium
  • Oil or soot in the actuator connector, corroded pins high
  • SENT signal wire chafed, open or shorted on the engine medium
  • Engine controller SENT input faulty low

Symptoms

  • MIL after two trips with the fault
  • Swirl flaps left in default position, slightly rougher or smokier low-load running
  • Often no noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U064F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication