OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U064B

Lost Communication With Hybrid/EV Battery Pack Current Sensor B

Some packs carry a second current sensor, B, often a different measuring principle than A, so that the battery controller can cross-check the two through P0B13 and still have a value if one fails. U064B is stored when that second digital sensor goes silent. No manufacturer publishes U064B. With only one remaining sensor the controller loses its redundancy; depending on the safety concept it may keep driving with sensor A but flag the fault, or reduce power until the plausibility check can run again. Sensors like LEM's CAB family send their readings as periodic CAN frames, so a missing frame stands out quickly. Section (e)(15.2.3)(A)(iv) of the CARB rule covers this input as well. An analog sensor B would instead log circuit faults P0B0E to P0B12.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 4B

Possible causes

  • Bus or supply wiring of sensor B damaged medium
  • Current sensor B failed medium
  • Missing or faulty CAN termination in the pack sub-network low

Symptoms

  • Battery system warning lamp
  • Correlation check between the current sensors no longer possible
  • Possibly reduced charging or drive power

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for U064B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication