U064A
Lost Communication With Hybrid/EV Battery Pack Current Sensor A
Battery management needs the pack current to count charge in and out and to judge state of charge and state of health. Many packs measure it with a self-contained sensor that sends its value over CAN; LEM's CAB series, for example, transmits on high-speed CAN at 500 kbit/s and is built for ASIL C. U064A records that current sensor A has stopped sending, while an analog sensor would report wiring faults via P0ABF to P0AC3. No manufacturer documents U064A publicly. CARB 1968.2 (e)(15.2.3)(A)(iv) requires the electronic inputs of the energy storage system to be monitored, which on hybrids points to a lit MIL. Without a current value the battery controller cannot track charge and normally restricts charging and discharging sharply.
Possible causes
- CAN, supply or ground wiring of sensor A inside or at the pack damaged medium
- Current sensor A failed medium
- Moisture or corrosion at the pack's low-voltage connector medium
- Battery energy control module fault or software low
Symptoms
- Hybrid or EV battery warning, on hybrids also the MIL
- Strongly reduced drive power or charging refused
- Implausible state-of-charge display
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for U064A
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.