OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0641

Lost Communication With EVAP System Pressure Sensor/Switch Circuit A

Pressure sensor A is the main input for the evaporative leak test that CARB 1968.2 (e)(4) requires: with the system sealed, the controller follows how pressure in tank and canister rises or falls. Newer designs often use a relative pressure sensor with SENT output; Melexis' MLX90821, for example, spans about −0.06 to 0.26 bar in its SENT version and can add a media temperature. U0641 means these digital messages are missing or unusable, which (e)(15.2.1)(B)(i) treats as its own fault; an analog sensor would log P0450 to P0454. Audi's 2.0 TFSI bulletin for 2021–2023 A4/A5 separates sporadic entries, caused by interference and fixed in the harness, from permanent ones that need normal diagnosis. The leak test stays blocked and the MIL is on.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 41

Possible causes

  • Electrical interference or damage on the sensor signal line high
  • Connector at the tank or canister sensor loose, wet or corroded medium
  • Pressure sensor A itself no longer sends medium
  • Sensor supply or ground missing low

Symptoms

  • MIL on
  • EVAP leak monitor not ready, possible inspection failure
  • No noticeable change in driving

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0641

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication