OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U0640

Lost Communication With EVAP Fuel Vapor Temperature Sensor Circuit

Many fuel tank pressure senders also measure the temperature of the vapor in the tank, and when such a sender reports digitally, typically over SENT, both values share one data stream. U0640 is stored when the engine controller no longer receives valid temperature data from this sensor. Despite the word circuit in the title, the fault concerns the digital link; an analog vapor temperature sensor reports wiring faults as P2024 to P2028. Audi documents U0640 together with U0641 for 2021–2023 A4 and A5 models with the 2.0 TFSI EA888: electrical interference on the vent system signal sets both codes sporadically, the cure is swapping two wires of a twisted bundle in the harness, and a new sender does not help. The MIL comes on, while the car drives normally.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 40

Possible causes

  • Interference or chafing on the shared signal line of the tank pressure/temperature sender high
  • Loose or corroded connector at the tank sender medium
  • Electronics of the sender failed (only if the code is stored permanently) low
  • Engine controller software or input fault low

Symptoms

  • Check engine light on
  • Often stored together with U0641
  • Evaporative system monitor does not complete

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U0640

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication