U063F
Lost Communication With Engine Coolant Flow Control Valve Position Sensor
The coolant flow control valve meters how much coolant passes through the engine, and its position sensor often transmits over SENT, a one-way digital protocol with a frame every few milliseconds. U063F flags the loss of that stream. GM's 2025 diesel tables (25OBDG04B) treat it as a Type B fault, with the MIL on the second trip, when 80 of 100 samples taken every 6.25 ms are bad: the last valid SENT frame is older than 6.25 ms while the line sits steady low or high, SENT frame errors are counted, or the pulse counter stops updating. The powertrain relay must supply more than 11 V and the engine must not be cranking. GM's harness chafing bulletin 21-NA-149 for 2019 to 2022 trucks and SUVs lists U063F among many codes. Analog-type sensor faults are P2B5D to P2B60 and P2B6D.
Possible causes
- Engine harness chafed through to the SENT, supply or ground wire (GM 21-NA-149) high
- Corroded or loose connector at the flow control valve medium
- Position sensor electronics in the valve failed (usually replaced with the valve) medium
- SENT input of the engine control module faulty low
Symptoms
- Check engine light after two trips
- Coolant temperature control less precise, slower warm-up or higher temperatures
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U063F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.