OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Network generic / SAE

U063E

Lost Communication With Exhaust Heat Exchanger Bypass Valve Actuator A

Exhaust heat recovery passes hot exhaust through a coolant heat exchanger after a cold start, so the engine and cabin warm up sooner; a flap later diverts the gas around it. When that flap's actuator is a LIN slave, losing it gives U063E. GM documents the check in its hybrid tables 16OBDG02 through 19OBDG02, run by the second hybrid powertrain control processor: with the controller on, Run/Crank active, LIN enabled for at least 2 s and battery voltage at least 10.2 V, 80 missed replies at 40 ms intervals (3.2 s) fail it as Type B, MIL after two trips. A stuck flap can slow warm-up or keep heating the coolant when it should not. Circuit and position faults of the flap are P237C to P237F and P2C22 to P2C25; actuator B is U066C.

SystemNetwork
Typegeneric / SAE
GroupU0
Range / number6 / 3E

Possible causes

  • Actuator electronics damaged by heat near the exhaust high
  • LIN or supply wiring under the vehicle damaged or corroded medium
  • Water ingress or corrosion in the actuator connector medium
  • Weak 12 V supply interrupting LIN communication low

Symptoms

  • MIL after two drive cycles
  • Slower engine and cabin warm-up in cold weather
  • Engine runs longer on hybrids to reach operating temperature

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for U063E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication