U0636
Lost Communication With Hybrid/EV Battery Pack Coolant Control Valve A
Battery thermal loops use motor-driven valves to send coolant through the chiller, the heater or a bypass, or to link the battery loop with the drive unit circuit. Many of these valves have a small controller of their own: Hutchinson's rotary three-way valve for electric vehicles talks LIN, and Thomas offers its coolant valves with PWM, LIN or CAN control and an optional self-diagnosis. U0636 is stored when valve A stops replying to the battery or thermal controller. No manufacturer documents the code publicly. Valve A then holds its last or default position, so the pack may be cooled or heated too little; CARB treats such valves on hybrids as monitored thermal management outputs. P0CDF to P0CE3 cover the electrical control circuit of the same valve.
Possible causes
- LIN, supply or ground wire to valve A damaged high
- Corroded or loose valve connector medium
- Valve A actuator electronics failed medium
- Thermal or battery controller software fault low
Symptoms
- Battery or hybrid system warning
- Reduced fast-charging power or limited drive power when the battery is hot or cold
- Cabin heating or cooling behaving differently
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for U0636
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.