U0632
Lost Communication With Fan 1
Many radiator fans now contain their own speed controller and take commands over LIN instead of relays. U0632 is set when fan 1 stops responding. GM (25OBDG03A, 25OBDG04B) fails it as Type B after 2.5 s without the fan's response frame and then suspends the fan speed checks P0494 and P30EE; the 2023/24 tables 23OBDG07 and 24OBDG07 allow three missed frames. Mitsubishi's 2023 Outlander PHEV assigns fan 1 to the right-hand radiator fan on LIN2 and sets the code after 2 s of failed communication. Mercedes bulletin LI20.00-P-076708 (GLC 254, GLE 167) reports the fan at full speed with a coolant warning and blames drivetrain controller software or LIN wiring; Audi bulletins for the Q7 cite chafed fan harnesses. Fans usually default to full speed.
Possible causes
- Fan harness chafed or pinched near the radiator or plenum (Audi bulletins) high
- Fan power feed (fusible link) or ground open medium
- Outdated software in the controller that runs the LIN bus (Mercedes PTCU) medium
- Electronics in fan 1 failed (replaced as fan assembly) medium
Symptoms
- Fan running continuously at full speed, loud
- Check engine light and coolant warning message
- On some Audi models limited engine speed or drive system fault message
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for U0632
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.