U062F
Lost Communication With Coolant Pump C
GM assigns coolant pump C to the pump of its low-temperature coolant loop, a separate circuit that runs well below engine temperature. The 2020 table 20OBDG04 fails U062F once LIN communication errors reach three counts, provided the bus itself is not already faulted (U1345), the pump is configured as present and run/crank voltage is at least 11 V. In 2025 (25OBDG04A) the test watches the pump's response frame CWP_Rsp and fails after 2.5 s without it. Both versions are Type B, so the MIL comes on after two trips. If the pump stays silent, the loop loses its circulation and the parts it cools can run hotter. Electric pumps like Bosch's PDE receive their speed command over LIN or PWM and report their own diagnosis.
Possible causes
- LIN wire, supply or ground to the low-temperature loop pump damaged high
- Corroded or loose pump connector medium
- Pump electronics failed medium
- LIN master in the engine controller faulty low
Symptoms
- Check engine light after two trips
- Parts on the low-temperature loop may run hotter than normal
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U062F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.