U0628
Lost Communication With A/C Refrigerant Pressure Sensor B
A second pressure transducer appears mainly in heat pumps and CO2 (R744) systems, where both the low and the high side are measured to control efficiency and detect leaks; the Sensata R744 presentation lists heat-pump control and leak diagnosis among those uses. U0628 means that the digital pressure value from sensor B no longer reaches its controller. If sensor A still reports while B is silent, the fault is likely in B's own branch, plug or electronics rather than in the controller. No manufacturer documents U0628 publicly. Losing the second pressure value usually ends heat-pump operation or forces a conservative compressor mode. Hardwired faults of the same sensor show as P2515 to P2518 or P05E2; disagreement between A and B is P2CD4.
Possible causes
- Damaged LIN, supply or ground wire in the branch to sensor B high
- Wet, corroded or loose connector at sensor B medium
- Sensor B electronics failed medium
Symptoms
- Heat pump does not heat, cabin heating relies on the auxiliary heater
- Weak or no A/C cooling
- A/C or thermal system warning message
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0628
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.