U0626
Lost Communication With A/C Refrigerant Pressure Sensor A
Without a refrigerant pressure reading the climate controller cannot protect the compressor or schedule the condenser fan. When pressure sensor A digitizes its value itself and transmits it as a LIN or SENT frame, U0626 marks that the frame has stopped arriving; which point of the circuit gets the letter A is up to the manufacturer. No manufacturer documents U0626 publicly. Audi illustrates the pattern with its combined sensor G395, which the body module polls as a LIN slave: if the air quality sensor drops out together with it, the shared LIN wire is usually pinched (Audi stores its own codes). The A/C normally shuts down until contact returns. Hardwired sensors report P0530 to P0533 instead, and P2CD4 compares sensor A with B.
Possible causes
- LIN wire to the sensor pinched, chafed or cut (Audi documents this for G395) high
- Corroded, loose or pushed-back terminals at the sensor connector medium
- Sensor supply voltage missing or ground intermittently open medium
- Sensor electronics failed, often after moisture or refrigerant leaking at the sensor low
Symptoms
- A/C compressor stays off, no cooling
- A/C fault message or flashing A/C indicator
- Other LIN devices on the same line may also report no communication
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for U0626
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.